Helmold Bender Bendall

Versatile 2 to 3 pt. Rule Bender Bendall

The Helmold Bender Bendall is a variation of the Helmold Standard Bender. It has an extended back block which allows either standard dies or bending mandrels to be used and permits closer bends and circular shapes to be produced which are beyond the capability of the standard Bender. The Bender Bendall comes with the standard accesssories listed in the following chart.

The optional 9-size Mandrel and Sleeve set shown on page 28, when combined with the standard accessories, makes a complete set of mandrels from 3/16” to 1”. The Bender Bendall is designed for use with rule up to 1” in height. Shipping weight is 66 lbs.

The Modified Bender Bendall

This bender has two design modifications as standard. Vise-action holders allow tightening of loose-fitting dies for precise alignment of our new or your worn bending dies. An Allen wrench is used to close the jaws. A locking dovetail back post is designed to deliver consistent bending even after years of use.

Helmold Bender Bendall with Bendall accessories.               Helmold Bender Bendall using dies.

Standard Bendall Accessories

Bender Bendall Parts